Termékek mepitel mepilex (4)

20,00 x 10,00 x 3,00 x 3,00 mm - 100,00 x 50,00 x 6,00 x 6,00 mm, DIN EN 10279 (DIN 1026), Abnahmeprüfzeugnis nach DIN EN 10204 / 3.1, AD 2000 - W2 / W10 4,00 - 6,00 m Werkstoffe: 1.4301/1.4307/TP304/TP304L 1.4571/ TP316Ti 1.4401/1.4404/TP316/TP316L 1.4541 / TP 321 1.4305 /TP303

Micro Tube SafeFit, 5.0 ml with Cap

Schluss mit Kaltakquise: Vorqualifizierte, kaufbereite B2B-Leads ab morgen in Ihrem Kalender! Stellen Sie sich vor, Ihr Vertrieb bekommt täglich exklusive Termine mit den entscheidenden Köpfen Ihrer Zielgruppe – ganz ohne Akquise-Stress. Wir liefern Ihnen qualifizierte Verkaufschancen direkt auf dem Silbertablett, damit Sie sich nur noch auf den erfolgreichen Abschluss konzentrieren.

In the injection moulding process TPE pellets are fed into the machine through a hopper and then into a heated barrel. The heat from the barrel turns the material into a liquid resin which is then injected into a closed mould under high pressure. After allowing the molten polymer to cool, the finished part can be removed from the mould. Injection moulding is a high-volume, high tooling cost process, the advanced properties of our TPE compounds deliver short cycle times allowing parts to be produced at a rapid rate. The information below is intended as a general overview, settings may vary depending on the specific grade selected. Please CONTACT US for detailed processing information Settings Equipment Conventional injection moulding machine Compression set At least 2:1. Special screws with short sections and higher compression ratios (3:1 to 4:1) may be good at low screw speeds Shrinkage Between 1.0% and 2.5% depending on the grade, type of application and location of the gate. Moul